User's Manual

29
Chapter 4 - Telnet
Assign Remote IP
Select Enable or Disable. If you select Enable, you will be prompted to enter an address to be
assigned to the remote system.
Remote Access
To configure the async port for Remote Access, enter values for each of the following:
Remote Access Port Settings
IP Assigned Method
Select the method the client will use to have their IP address assigned.
Protocols
Default value is Both IP and IPX enabled. You may select to use only one protocol, however if you
are connecting to a Netware server, you must have IPX enabled.
IPX/SPX Frame Type
The default value is Autodetect. If you have problems with your network connection, you may select
Ethernet_II, Ethernet_802.3, Ethernet 802.2 or Ethernet_snap.
Authentication Method
Select either None, PAP or CHAP. Refer to the RouteFinder Manager chapter of this User Guide for
additional information.
Edit User Database
To add users to the database, select the next available letter. Enter the User Name, Password and
Callback type for each user that you add to the database. You may enter up to 64 remote clients.
Idle Timeout
The default value is 5 minutes.
Serial Baudrate
Select one of the available options. You may need to use a slower speed to ensure a quality
connection.
Modem Pre-initial string
Refer to your modem or ISDN TA User Guide for information. The default value will work for most
analog modems.
Modem Initial string
Refer to your modem or ISDN TA User Guide for information.
Modem Dialup string
Refer to your modem or ISDN TA User Guide for information.
Modem Hangup string
Refer to your modem or ISDN TA User Guide for information.
Edit login script
Select this option to edit the login script executed when the client connects to the network. Refer to
the RouteFinder Manager chapter of this User Guide for additional information about creating and
editing scripts.