User's Manual

28
Chapter 4 - Telnet
Async Port Settings
The async port may be used for IP Routing or Remote access. For more information, see the Async
Port section of the RouteFinder Manager chapter.
IP Routing
If you will use the async port for IP Routing, enter the following information as described:
Telephone number
Enter the phone number the async device must dial to connect to the remote system.
User Name
Enter the User Name that will be used for authentication on the remote system.
Password
Enter the Password associated with the User Name for the remote system.
Idle Timeout
Enter the amount of idle time allowed to pass before the connection times out. The default value is 5
minutes.
Serial Baudrate
Use the list to select the appropriate baudrate of the modem attached to your async port. You may
need to select a lower speed to ensure a quality connection.
Modem Pre-Initial string
Consult your modem or ISDN TA User Guide for this information. The default value will work for most
analog modems.
Modem Initial string
Consult your modem or ISDN TA User Guide for this information.
Modem dialup string
Consult your modem or ISDN TA User Guide for this information.
Modem hangup string
Consult your modem or ISDN TA User Guide for this information.
Login script
Select Enable or Disable.
Edit login script
Refer to the RouteFinder Manager chapter of this User Guide for information on editing scripts.
External IP address
Enter the IP addresss of the remote device to which you are connecting.
NAT Function
Select Enable or Disable. Refer to the Glossary in this User Guide for additional information on NAT.