- Power Measurement Modem User's Guide

ION 7500 / ION 7600 User’s Guide Data Logging Setup
Chapter 3 - Default Meter Functionality Page 57
Sag/Swell and Transient Logging
The meter logs the following ION output register values:
EN50160 Compliance Logging (ION 7600 only)
By default, 22 Data Recorders are used for logging EN50160 compliance
parameters.
The ION 7600 logs EN50160 counter data for current and previous observation
periods. EN50160 events are also logged. EN50160 parameter data logging (from
seven “Prm” data recorders) is disabled by default. The EN50160 Parameter
Logging enable is accessible in the default Power Quality Vista diagram. For more
information about EN50160 data logging, refer to the technical note Power Quality:
ION Meters and EN50160.
Sag/Swell Log
DistDur DistV2Engy DistV1Engy DistV3Engy
DistV1Min DistV3Min DistV2Min DistNominal
DistV1Max DistV3Max DistV2Max SwellLim
DistV1Avg DistV3Avg DistV2Avg SagLim
Transient Log
TranV1Dur TranNominal TranV2Max PT Sec
TranV1Max Threshold TranV3Dur CT Prim
Tran V2Du r PT Prim TranV3Max C T Sec
Data Recorder
EN50160
Component Logged
Data Recorder
EN50160
Component Logged
EN50160 Frq/Mg
Power Frequency and
Supply Magnitude
EN50160 Vunbal Voltage Unbalance
EN50160 Flicker Flicker EN50160 Hrm Vlt
Harmonics
(up to 40th)
EN50160 Vlt Dp1
Supply Voltage Dips
EN50160 Ihm Vlt
EN50160 Vlt Dp2 EN50160 MSignal
Mains Signalling
Voltage
EN50160 Vlt Dp3 EN50160 Prm-f/V
Parameter data
These data recorders
are disabled by
default (see below).
EN50160 Vlt Dp4 EN50160 Prm-Flk
EN50160 Vlt Dp5 EN50160 Prm-VDp
EN50160 Intrp
Short/Long
Interruptions
EN50160 Prm-Vlr
EN50160 Ovrvlt1
Temporary
Overvoltages
EN50160 Prm-OV
EN50160 Ovrvlt2 EN50160 PrmHrm1
EN50160 Ovrvlt3 EN50160 PrmHrm2