User manual

MultiModemISI Hybrid Series, ISIHI-2S 53
Chapter 3—Software/Driver Installation
Troubleshooting
Problem: I loaded the driver at the file server console, then I started NetWare Connect
and connected a modem to a port on an ISIHI-2S. When I try to communicate with the
modem, I see the DTR of the modem being raised, but the modem does not respond to
my AT commands.
Solution: There might be an IRQ conflict between an ISIHI-2S and some other hardware
in your system. Even though that particular device (for example, a mouse) is not
activated under NetWare, that device will still control the IRQ. Refer to your system’s
documentation to find out how to disable that device.
Configuring Ports for NetWare Connect
To set up NetWare Connect ports, enter LOAD NWCCON at the NetWare console
prompt. LOAD NWCCON opens the NetWare Connect Configuration Utility. Select the
appropriate menu options (modem type, speed, flow control, etc.)
Removing the Driver (Novell)
In Novell, remove file AIOISIX.NLM from the system directory and make the appropriate
changes to the Autoexec.ncf file.