Specification
Section V-Reactivity Data
Unstable
Conditions to Avoid Strong oxidizing agents, fire, flame
Stability
Stable
X
Incompatibility (Materials to Avoid) Strong oxidizers, acid and alkalis
Hazardous Decomposition or Byproducts Unlikely
May Occur
Conditions to Avoid Keep away from heat, sparks and open flame.
Hazardous
Polymerization
Will Not Occur
X
Section VI-Health Hazard Data
Route(s) of Entry:
Inhalation: At very high concentrations inhalation causes headaches, dizziness, drowsiness, and nausea, and may lead to
unconsciousness. Slightly irritating to the respiratory system (redness).
Ingestion: Extreme levels can cause nausea, headache and vomiting, or higher levels may cause unconsciousness.
Skin/Eye Contact: May cause eye irritation (redness).
Health Hazards (Acute and Chronic) Direct contact or exposure to mists and vapor may cause slight to moderate eye irritation.
Prolonged or repeated exposure to product, vapors or mists may cause slight skin irritation. Ingestion may cause moderate to
severe irritation of the respiratory tract.
Carcinogenicity: NTP? NO IARC monographs? NO OSHA Regulated? NO
Signs and Symptoms of Exposure: Very low evaporation unlikely to reach exposure limits.
Medical Conditions Generally Aggravated by Exposure None established
Emergency and First Aid Procedures General: Protection of first-aider: Put on appropriate personal protective equipment.
Move exposed person to fresh air. Remove contaminated clothing and shoes.
Inhalation: If inhaled, remove to fresh air. Prevent cooling of the person. Keep victim at rest in half upright position. If not
breathing, give artificial respiration. Obtain medical attention.
Ingestion: If swallowed, rinse mouth with water (only if person is conscious). Seek medical attention.
Skin Contact: Wash with soap and water. Remove contaminated clothing and shoes. Obtain medical attention if symptoms occur.
Eye Contact: Rinse with plenty of running water. Obtain medical attention if symptoms occur.
Section VII-Precautions for Safe Handling and Use
Steps to Be Taken in Case Material is Released or Spilled Soak up with suitable, non-reactive absorbent material, collect in
suitable containers for disposal.
Waste Disposal Method Dispose of in accordance with all local, state and federal regulations.
Precautions to Be Taken in Handing and Storing Store at temperatures between 40
◦
F - 95
◦
F
Section VIII-Control Measures
Respiratory Protection (Specify Type) Wear filter mask, filter type A
Local Exhaust Use with adequate ventilation Special N/A
Ventilation
Mechanical (General) Exhaust preferred and recommended Other N/A
Protective Gloves Neoprene gloves Eye Protection Safety glasses with side shield
Other Protective Clothing or Equipment Filter mask, filter type A
N/A = Not applicable.