Use and Care Manual

Multi-Pro 47-110 Series
Architectural Coatings PPG Multi-Pro Interior Latex Wall & Ceiling Paint Flat
47-110 1/2020
PPG Architectural Finishes, Inc. believes the technical data presented is currently accurate: however, no guarantee of accuracy, comprehensiveness, or performance is given or implied.
Improvements in coatings technology may cause future technical data to vary from what is in this bulletin. For complete, up-to-date technical information, visit our web site or call 1-800-
441-9695.
PPG Industries, Inc.
Architectural Coatings
One PPG Place
Pittsburgh, PA 15272
www.ppgpaints,com
Technical Services
1-800-441-9695
1-888-807-5123 fax
PPG Architectural Coatings Canada Inc.
1550 rue Ampère, Suite 500
Boucherville (Quebec) J4B 7L4
Architect/Specifier
1-888-PPG-IDEA
© 2019 PPG Industries, Inc. All Rights Reserved. The PPG logo is a registered trademark of PPG Industries Ohio, Inc. Multi-Pro is a registered trademark of PPG Architectural Finishes,
Inc.
APPLICATION INFORMATION
Stir thoroughly before using and occasionally when in use. When using more than one can of the same color, intermix to ensure color uniformity.
USE WITH ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN. Read all label and Safety Data Sheet (SDS) information prior
to use. SDS are available through our web site or by calling 1-800-441-9695.
Application Equipment: Apply with a high quality brush, roller, paint pad, or by spray equipment. Where necessary, apply a second coat and
allow each coat to dry thoroughly before applying the next coat.
Airless Spray: Pressure 2000 psi, tip 0.015” - 0.021”. Spray equipment must be handled with due care and in accordance with manufacturer’s
recommendation. High-pressure injection of coatings into the skin by airless equipment may cause serious injury.
Brush: Polyester/Nylon Brush
Roller: 3/8” - 3/4” nap roller cover
Thinning: Do not thin.
Permissible temperatures during application:
Material: 50 to 90ºF 10 to 32ºC
Ambient: 50 to 90ºF 10 to 32ºC
Substrate: 50 to 90ºF 10 to 32ºC
PRECAUTIONS
WARNING! HARMFUL IF SWALLOWED. Sanding and grinding dusts may be harmful if inhaled. This product contains crystalline silica which can cause
lung cancer or silicosis. The risk of cancer depends on the duration and level of exposure to dust from sanding surfaces or mist from spray applications. Do not
breathe vapor or mist. Do not swallow. Do not get on skin or clothing. Keep container tightly closed and sealed until ready for use. Wash thoroughly after han-
dling. Provide fresh air ventilation during and after application and drying. Avoid the inhalation of dust, particulates, spray or mist arising from the application of
this preparation. Use personal protective equipment as required. Note: These warnings encompass the product series. Prior to use, read and follow prod-
uct-specific SDS and label information. FIRST AID: If swallowed, rinse mouth with water (only if the person is conscious). Call physician immediately. Do not
induce vomiting unless directed to do so by medical personnel. If in eyes, rinse with water for 15 minutes. Check for and remove any contact lenses. If on skin,
rinse well with water. Wash with soap and water. Get medical attention if irritation develops. If inhaled, remove to fresh air. If experiencing respiratory symptoms
call a POISON CENTER or doctor/physician. Keep out of the reach of children. For workplace use, an SDS is available from your retailer or by calling (412) 492-
5555. EMERGENCY SPILL INFORMATION: [phone] (U.S.).