Owner`s manual

FUEL FILTER CUP

FUEL VALVE

Figure 24- Removing the Fuel Filter Cup

Spark Plug Maintenance

The spark plug is importa nt for proper engine operation. A good spark plug should be intact, free of

deposits, and properly gapped. To inspect the spark plug:

1. Pull on the spark plug cap to remove it.

2. Unscrew the spark plug from the generator using the spark plug wrench included with this

product (see figure 2 5).

3. Visually inspect the spark plug. If it is cracked or chipped, discard and replace with a new

spark plug.

4. Measure the plug gap with a gauge (see figure 2 6). The gap should be 0.7 -0.8mm (0.028-

0.031in).

5. If you are re-using the spark plug, use a wire brush to clean any dirt from around the spark plug

base and then re-gap the spark plug.

6. Screw the spark plug back into its place on the generator using the spark plug wrench. Place

back the spark plug cap.

PLUG WRENCH

PLUG CAP

Figure 25- Removing the spark plug Figure 2 6- Measuring the spark plug gap