Owner`s manual

16
Step 2 – Check the Gas Level
Before starting the generator , check to see that there is sufficient gasoline in the gas tank. The fuel
gauge on top of the generator will indicate the gas level in the tank. Add gas if necessary according to
the steps in the “Adding Gasoline” portion of the “Maintenance” section.
WARNING: Gasoline and gasoline fumes are highly flammable.
 Do not fill tank near an open flame.
 Always allow engine to cool for several minutes before refueling.
 Do not overfill (check the “Specifications” section for the tank capacity of your generato r).
Always check for fuel spills.
IMPORTANT:
 Use only UNLEADED gasoline with an octane rating of 87 or higher.
 Do not use old gas.
 Never use an oil/gasoline mixture.
 Avoid letting dirt or water into the fuel tank.
 Never store generator for extended per iods of time with fuel in the tank.
Step 3- Ground the Generator
WARNING: Failure to properly ground the generator can result in electrocution.
Ground the generator by tightening the grounding nut against a grounding wire (see figure 11). A
generally acceptable grounding wire is a No. 12 AWG (American Wire Gauge) stranded copper wire.
This grounding wire should be connected at the other end to a copper or brass grounding rod that is
driven into the earth.
Grounding codes can vary by location. Please contact a local electrician to check the grounding
regulations for your area.