Owner`s manual

11
The new generator comes with the bolt, bushings, and nut attached to the fram e. To attach the
handle, first remove these pieces from the frame.
2. Place one bushing into each hole of the handle bracket. The head (large part) of the bushing
should be on the inside of the bracket.
3. Line up the holes on the handle bracket, with bushings attached, the holes on the generator frame.
4. Secure the handle to the frame using the bolt and nut. Make this attachment so that the nut is on
the inside of the frame.
5. Repeat steps 1-4 for the other handle.
At this point, gently remove the two wheels from underneath the generator.
a b
Figure 3- handle assembly
Attach Wheels
To attach the wheels to the generator, perform the following steps:
1. Find a wood block or s imilar item that is 3 inches thick or greater and rest the exhaust end of the
generator on the block as shown in figure 4.
2. Take one wheel shaft, one spacer, and one M12 nut as shown. Place the spacer between the two
holes on the frame bracket. Slide the wheel shaft, with the threaded part facing inward, through the
frame and spacer. Secure using an M12 nut and the included wrench as shown in figure 5.
3. Slide the wheel onto the axle and secure in place using a large cotter pin as shown in figure 6.
Spread the pin legs apart slightly to help secure the pin in place.
4. Repeat steps 2 and 3 for the other wheel.
At this point, the generator assembly is complete. Gently remove the generator from the wood block.
Figure 4- supporting the generator Figure 5 - axle assembly
a b