Owner`s manual

10
ASSEMBLY
In order to best protect the generator wh ile in the package, this product comes with some components
disassembled. Please complete the following assembly steps before proceeding to use the generator.
For ease of assembly, we recommend attaching the components in the order listed in this manual.
If after reading this section, you are unsure about how to perform any of the steps, please call
[phone] M-F 8-5 CT for customer service.
WARNING: This generator is heavy. Some assembly procedures may require two people.
Attach Feet
To attach the feet to the generator, perform the following steps:
1. Stack the two generator wheels on top of each other. Lift the end of the generator that has the
recoil starter onto the stack of wheels (see figure 1). Be careful not to obstruct any holes on the
generator.
2. Place one leg onto the frame as shown in figure 2. Line up the holes on the generator frame with
the holes on the bracket portion of the leg. Tighten using two M6x40 bolts, two M6 nuts, and the
included wrench.
3. Repeat step 2 for the other generator leg.
Figure 1- Stacking the wheels
a b
Figure 2- foot assembly
Attach Handles
The handles attach to the same end of the generator as the feet. To attach the handles to the generator,
perform the following steps:
1. The handle assembly consists of the handle, bolt, two bushings, and a nut as shown in figure 3.