Technical information

hp officejet 5500 series
chapter 12
98
fax setup
how to answer fax calls manually
To receive faxes manually, you must be available to respond in person to
incoming fax calls or your HP Officejet cannot receive faxes.
Before you can answer fax calls manually, you must change the Rings to Answer
setting to No Answer as described in set the number of rings before answering
on page 39. For information about how to receive fax calls manually from your
attached phone and from an extension phone, see receive a fax manually on
page 40.
case D: fax line shared with PC modem (no voice calls
received)
If you have a fax line on which you receive no voice calls, and you also have a
PC modem connected on this line, connect your HP Officejet as described in this
section.
Note: Since your PC modem shares the telephone line with your
HP Officejet, you will not be able to use both your PC modem and your
HP Officejet simultaneously. For example, while you are sending and
receiving faxes, you will not be able to e-mail or access the Internet.
1 Remove the white plug from the port labeled “2-EXT” on the back of your
HP Officejet.
2 Find the phone cord that connects from the back of your computer (your
PC modem) to a telephone wall jack. Disconnect the cord from the
telephone wall jack and plug it into the port labeled “2-EXT” on the back
of your HP Officejet.
3 Using the phone cord supplied in the box with your HP Officejet, connect
one end to your telephone wall jack, then connect the other end to the port
labeled “1-LINE” on the back of your HP Officejet.
Caution! If you do not use the supplied cord to connect from the
telephone wall jack to your HP Officejet, you probably will not be
able to fax successfully. This special 2-wire cord is different from
the more common 4-wire phone cords you might already have in
Telephone
wall jack
Back view of the HP Officejet
PC with modem
Use t
h
e p
h
one cor
d
supplied in the box with
your HP Officejet