Specifications

Programmable Features Continued
Do’s and Don’t Of SAC Programming
• 1 Digit Security Access Codes ARE NOT recommended. (refer to
“Programming
” Section, page 9).
• DO NOT use the codes “9”, “#”, “##”, or anything beginning with “9”
or “##”. These codes are reserved of the “Call Grab” feature and
the programming access to The Stick, respectively.
• DO NOT select an access code that may be the first part of a dialed
number or control code of your answering machine.
Factory preset Security Access Codes are as follows:
Touch Tone Pulse Dial
Voice 1 and Voice 2 Ports - *1 None
FAX Port - *2 2
MODEM Port - *3 None
• Pulse Detection-The Pulse Detection feature, when activated, allows The
Stick to detect the factory-preset code "2" and "Call Grab" preset code "9"
when dialed from a pulse dial phone.
The factory preset for this feature is "off."
• Rings To Answer- This feature directs The Stick to answer an inbound
call after a programmed number of phone company rings (0 to 10 rings)
from the phone company.
If RTA is programmed to "0", The Stick will answer the call during the first
ring. Extension phones elsewhere in your location will only "chirp" the first
ring before going quiet.
If the RTA is greater than "0", The Stick will allow all incoming calls to ring
extensions and devices connected to the ports labeled VOICE 1 and
VOICE 2 for the programmed number of rings.
Factory preset is 0 rings.