Specifications

Programming Commands continued
1. Since five seconds has more than elapsed since you initiated the your
mom, you can enter the programming mode. You dial " # # 7 7” on your
touch-tone phone connected to the “VOICE 1"' port.
The Stick Response: Answers with a “PROCEED” tone. The LED is
blinking very rapidly. You have 30 seconds to begin the next command.
2. You change the SAC for the MODEM port to “007”, by dialing 13007, “13”
selects Register 13 (Security Access Code for MODEM port) and 007 is
the new SAC.
The Stick Response: Answers with an “OK” tone, then a “PROCEED”
tone. You have 30 seconds to begin the next command.
3. You change the “Unrestricted Manual Transfer” feature to “OFF” (factory
preset “ON”) by dialing 070. “07” selects Register 7 and "0" turns the
feature off.
The Stick Response: Answers with an “OK” tone, then a “PROCEED”
tone. You have 30 seconds to begin the next command.
4. You change the “Pulse Detect” feature to “ON” (factory preset “OFF”) by
dialing 051. "05" selects Register 5 and "1" turns the feature on.
The Stick Response: Answers with an “OK” tone, then a “PROCEED”
tone. You have 30 seconds to begin the next command.
5. You have finished programming the desired feature changes and wish to
save them to nonvolatile memory and exit the programming mode. You
dial “80”.
The Stick Response: Answers with the “OK” tone twice. The LED returns
to normal blinking which demonstrates that your touch-tone phone
connected to the “VOICE 1" port is off-hook.
Check and see if your mom is on the other end of the line.
If not, hang up the phone.
NOTE: If The Stick does not receive a command within 30 seconds, it will give
you an “OK” tone and exit the programming mode without saving any
programming. Basically it is acting as if you have dialed "90".
(See section titled Programming Commands
.)