Specifications

Initial Check
Included with The Stick are additional items that make life a whole lot easier.
Please check the box and make sure you have:
• The Stick™ Voice/Fax/Modem Call Processor
• One 12 Volt Class 2 Power Source
• One Silver Modular Line Cord
If any of these items are missing,
please alert the Sales
Department toll free at 866-337-
0965 and also Technical Support
at 800-535-4651
POWER UP
The first thing you must do before programming The Stick is to "power up" the
unit. It is recommended that you choose a power outlet close to a telephone wall
jack. Plug the power supply (supplied) into the 110 volt outlet and insert the
barrel plug into the port labeled:
USE ONLY WITH
12 VAC 0.8-1.0A
CLASS 2
POWER SOURCE
At the rear of the unit. The red light beside "The Stick" logo should be lit at this
time.
CONNECTING TO THE PHONE LINE
Before programming The Stick, you will need to
install it on your existing telephone line and connect
a touch-tone (DTMF) telephone to the port labeled
"VOICE 1" at the bottom of the unit.
A silver Modular Line Cord has been supplied for
connecting The Stick to a phone line. Plug one end of the line cord into the port
labeled "LINE". Plug the other end into a telephone wall jack. At this time you
should hear dial tone when the handset on your touch-tone phone is lifted
off-hook.