Programming instructions

Question: I only want to connect 1 telephone line to the STICK II. Will it work?
Answer: The STICK II must be programmed for 1 line operation. See
Sections 3
of the Operations Manual and set registers 20
through 24 to a value of 10 (example for register 20 enter 2010). Set register 25
to value of 1.
Question: Can I program the STICK II from a remote location?
Answer: Yes, but you must ha
ve someone at the STICK II location initiate a call
to you from a phone attached to Voice 1 on Line 1 of
the STICK II. After you answer, with the caller on the line, programming codes
can be entered from either location.
Power Stone Questions and Answers
Question: Can I control DC power with the POWER STONE?
Answer: No, the POWER STONE is only available for control of sinusoidal 120V
AC power.
Question: I forgot my special programming security code or it d
oesn’t work. How
can I recover?
Answer: After the POWER STONE is initially connected to power, programming
mode can be entered by using only the # # 88
command. The special security code in register 6 is not needed the first time
programming is entered.
Use this one time only (after a
power cycle) to recover a lost or inoperative situation by resetting to Factory Pre
-
Sets and re
-
programming any custom settings.
Question: Is the POWER STONE capable of Distinctive Ring Recognition?
Answer: Yes. See
programming register 3 in Operations Manual.
Question: My programming changes aren’t working. Why?