Programming instructions

Question: Incoming calls that are intended for equipment on a port other than
Device 1 are still ringing on the phone.
Why?
Answer: Insure the calling equipment is using the correct Security Access Code
(SAC) stream as shown in the Operations Manual
Section 2.2.
Question: Can I connect more than 1 modem to the ATX?
Answer: Generally, any analog telephony equip
ment can be attached to any
device port as desired to meet individual needs.
Question: I am only sharing this line for Fax and Modem type equipment with no
inbound voice calls. What is the best
installation configuration?
Answer: Recommend connec
ting the FAX to Device 1 and change Dip switch 6
to the “off” position. This will let all FAX calls, with
and without CNG tone, find the FAX machine. The Fax port can be used for any
other equipment, including a phone for outbound
calls.
SR Questio
ns and Answers
Question: The phones on the SR do not ring with the first ring from the phone
company. Why?
Answer: The SR does not answer the incoming call, but must count the ring
bursts in the first ring interval to determine which device
port to present with ring voltage. This means the first TELCO ring is “captured”
by the SR. Any devices on the line (ahead of) side of
the SR will see all rings and all patterns.
Question: Will Caller ID work on the SR?
Answer: Yes, but only on th
e line side of the SR without a special installation
work
-
around. If CID pass
-
through is required, contact
our Technical Support Department to obtain details.