Specifications
The Stick II
32
If the call coming in is a fax, however, The Stick II will detect the CNG
tones and route it to the programmed fax default port. If your fax ma-
chine does not hand shake with the calling fax machine, for whatever
reason, then The Stick II will drop the call after the programmed Maxi-
mum Rings.
Unrestricted Manual Transfer (UMT)
The UMT feature, when ON, enables a transfer to be executed at any time. When
UMT is OFF, The Stick II will only allow a transfer during the first 15 seconds of an
inbound call. Depending on the Security Access Codes you have chosen, there could
be a conflict if you dial an automated system. You can either turn this feature off or
change your SAC code. Factory preset is ON.
Q:Cant I transfer at any time if I know the Security Access Code for the
port I want?
A:No. If UMT is OFF, you can only transfer during the first 15 seconds of
an INBOUND CALL. That goes for the caller and you, the receiver. If
UMT is ON, then yes, you or the caller can transfer at any time.
Q:What about an extension phone, one not plugged into The Stick II ,
but on the same line?
A:Yes, you can enter transfer codes from phones not attached to The Stick
II. The Stick II is always listening. However, if UMT is OFF, and you are
using an extension phone, both you and the caller only have 15 seconds to
transfer the call.
4.3 Unique Features
Auto-Line Selection
This feature allows you to set and control each ports access to outbound lines. See
Section 3.4 to find out the default outbound line for each port. By turning this feature
OFF, you restrict that ports access to only its default line. By turning the Auto-Line
Selection ON, if the default line chosen for that port is busy, the port will access the
other phone line to make the call.