Specifications
The Stick II
19
PROGRAMMING EXAMPLES
Turning ON your Unanswered Call Silent Transfer LINE 2
DIAL 041 04 is the Register Number and 1 is the Program Range which means
ON
Immediately listen for the OK tones (Bee-Bip), then the PROCEED tones (Bee-
Bee-Beep) or ERROR tones (low pitch beeps) then proceed. You have 30 seconds
to begin the next command.
Changing your Rings to Answer (RTA) LINE 1 and suppressing the
devices connected to Voice 1 from ringing during the RTA
DIAL 1541 15 is the Register Number, next enter the Program Range of 41.
"4" is the number of rings that will occur on every Line 1 phone before The Stick II
takes the call and processes it and 1 tells The Stick II to suppress any of the devices
hooked to Voice 1 from ringing until after the 4
th
ring.
Immediately listen for the OK tones (Bee-Bip), then the PROCEED tones (Bee-
Bee-Beep) or ERROR tones (low pitch beeps) then proceed. You have 30 seconds
to begin the next command.
Changing the Security Access Code for Port 3
DIAL 1137
*
6 11 is the Register Number and the Program Range is 37
*
6
the new access code for Port 3. See the Donts of SAC Programming before select-
ing your Access Code.
Immediately listen for the OK tones (Bee-Bip), then the PROCEED tones (Bee-
Bee-Beep) or ERROR tones (low pitch beeps) then proceed. You have 30 seconds
to begin the next command.
DONT FORGET TO SAVE AND EXIT PROPERLY
DIAL 80
You will hear the OK tone TWICE (Bee-Bip, Bee-Bip). The LED will go back to
normal operation.
Remember: The only reason you would hear an error tone when saving and exiting is if you have programmed
all ports to default to Line 2 (can't enter programming mode from Line 2) and Auto-Line Select OFF on ALL
ports. You will be unable to Save & Exit until the situation is remedied. Assign a port to default to Line 1 or turn
Auto-Line Select ON for at least one port.
Programming complete and changes are saved.