Specifications

The Stick II

3.3 How to Program a Feature

You are ready to begin programming. Keep in mind that all the program-

mable features are set to the factory default. You do not have to go through this

procedure unless you want to turn a feature OFF or ON, change the number of

rings, security access code(s) or destination port(s).

When entering the programming mode The Stick II will signal you with audible

beeps from the handset. These beeps tell you that you have entered the programming

mode OK and to PROCEED. You will have 30 seconds to enter your next command.

Your next command could be to modify a feature or to save and exit. If nothing is

entered within those 30 seconds, The Stick II will signal with the OK beep. Your

programming changes will not be saved and you will have exited the programming mode.

It is as if you DIALED 90 for the No Save/Exit command.

Entering Programming Mode

 Place a call to your friend from LINE 1. (Do not call into LINE 2.)

 Wait at least 5 seconds before continuing.

 DIAL # # 9 9 on your telephone key pad. The LED will begin blinking rapidly.

 Immediately listen for the PROCEED (Bee-Bee-Beep) tones. You have 30 seconds

to begin programming.

You are now ready to modify any programmable feature.

 DIAL the Register Number of the feature you want to modify. (see chart on p. 20-24)

 Next DIAL in the Program Range. (see chart on p. 20-24)

 Immediately listen for the OK tones (Bee-Bip), then the PROCEED tones (Bee

Bee-Beep) or ERROR tones (low pitch beeps) then "PROCEED". You have 30

seconds to begin the next command.O