Specifications
The Stick II
17
HOW TO SAVE & EXIT
Once you have entered programming mode (explained on the next page), you will
need to be familiar with these instructions in order to insure your changes are saved and
that you have exited properly.
Save to Memory / Exit - After entering the programming for the features you
wanted modified, you will need to save the changes to memory and exit the program-
ming mode. The Stick II maintains the programming even if there is a loss of power.
Dial 80
Next you will hear the OK tone TWICE (Bee-Bip, Bee-Bip). The LED will go back to
normal operation.
The only reason you would hear an error tone when saving and exiting is if you have
Auto-Line Select OFF on ALL ports AND programmed all ports to default to Line 2
(Remember, you can't enter programming mode from Line 2). You will be unable to
Save & Exit until the situation is remedied. Assign a port to default to Line 1 or turn
Auto-Select ON for at least one port.
No Save / Exit - You can cancel any programming youve done and exit the
programming mode at any time.
Dial 90
You will hear the OK tone ONCE (Bee-Bip). The LED will go back to normal operation.
Set Register to Factory Preset - This command sets all of the Registers back to
the factory presets. See your Programming and Quick Reference Guide for the factory
presets.
Dial 60
You will hear the OK tone ONCE (Bee-Bip) immediately followed by the PROCEED
tone (Bee-Bee-Beep).
Dial 80 to save and exit.
Next you will hear the OK tone TWICE (Bee-Bip, Bee-Bip). The LED will go back to
normal operation.