Operating instructions

3) If you disconnect the incoming line from a jack, label the existing jack
“TELEPHONES”. If you did not, install a jack, label it “TELEPHONES”, and
connect the two wires going toward your phone equipment to the RED
and GREEN terminals of this new
jack.
4) Mount a modular jack* at the location of your SR and connect the
telephone company incoming line to the RED and GREEN terminals. It
may be necessary to run additional station wire* from the incoming
line.
Label
this jack “LINE”.
5) Connect the “LINE” input of your SR to the modular wall jack marked
“LINE” with the supplied line cord. Connect the wall jack marked
“TELEPHONES” to the DEVICE 1
jack on your SR with a line cord.
6) Attach any other telephones or data equipment to the other DEVICE
jacks
on your SR.
7) If you need to attach
an additional telephone to DEVICE 1 at the SR,
you can use a telephone line “Y” adapter* to allow you to plug two line
cords into the DEVICE 1
jack.
* Refer to Recommended Parts and Materials Section, page 22.
SR Series
13