Installation manual

66
Installing the Bottom Pan
Installation
NOTE: Anti-seize lubricant applied to the threads of the stainless
steel mounting hardware is recommended.
1. Remove the four 1/4-20 x .75 screws, lock washers and flat washers
attached to the front of the bottom pan. These will be re-installed in
Step #3.
2. Rear Mounting Bolts - Position the bottom pan under the unit and
align the four holes in the rear of the bottom pan with the four holes in
the rear of the frame.
• From under the unit, attach the rear of the bottom pan with the four
1/4-20 x 1.00'' torx head screws, 1/4” lock washers and 1.00''
diameter flat washers supplied in the installation kit.
3. Front Mounting Bolts - Open the center curbside and roadside doors
to access the bottom pan front mounting tabs.
• MODEL 30 Units - From inside the unit, secure the bottom pan
with the four 1/4-20 x .75'' screws, lock washers and flat washers
removed in Step #1.
• MODEL 50 Units - The receptacle box needs to be lifted up to
access one of the bottom pans front mounting bolts.
• Remove the front bolt securing the receptacle box to the frame.
Loosen the rear bolt securing the receptacle box to the control
box. Lift the receptacle box up. From inside the unit, secure the
bottom pan with the four 1/4-20 x .75'' screws, lock washers and
flat washers removed in Step #1.
4. Torque all eight bottom pan mounting bolts to 30 in-lb.
• MODEL 50 Units - Reinstall the receptacle box securely.
5. Close and secure all doors.