Installation manual

Connecting the CargoWatch™ Sensors (Option)

NOTE: ONLY CargoWatch Sensors Can Be Used

CONNECTING SENSORS

NOTE: The sensor are not polarity sensitive.

1. Locate the CargoWatch Sensor Harness behind the evaporator access

panel.

2. Unplug the connector from the harness.

3. Removes orange end from connector.

4. Remove only the plugs from the connector holes for the sensors you are

connecting. Unused holes must remain plugged.

5. Insert WHITE pin connector and wire into correct connection until it

locks into position (Detail I). The wire side of the connector is shown.

6. Insert BLACK pin connector and wire into correct connection until it

locks into position (Detail I). The wire side of the connector is shown.

Reinstall orange end (3) back onto connector (2), apply a light coating

of Superlube to electrical connections and plug sensor back into mating

connector on the Sensor Harness (1).

7. Connect the CargoWatch Sensor Harness to the sensor using the splice

connectors. Crimp splice connectors securely and apply heat with a

heat gun. NOTE: The CargoWatch Sensor wires are not polarity

sensitive.

8. Secure sensor with appropriate clamps.

SENSOR PLUGS

1 #1 and #12

2 #2 and #11

3 #3 and #10

4 #4 and #9

5 #5 and #8

6 #6 and #7

SENSOR PLUGS

1 White into #1

2 White into #2

3 White into #3

4 White into #4

5 White into #5

6 White into #6

SENSOR PLUGS

1 Black into #12

2 Black into #11

3 Black into #10

4 Black into #9

5 Black into #8

6 Black into #7