Installation manual

52
Installing the Rear Remote Controller (Option)
Foamed-In-Place Installation
NOTE: Verify mounting location and all dimensions before installing
the remote controller.
A = 69.8 mm (2.75 in.)
B = 196.8 mm (7.75 in.)
Preferred Wire Routing (Steps 1,2, 6-10)
NOTE: The preferred routing of the electrical harness chase and
interface harness is from the bottom
of the controller box.
1. Connect the harness chase to the bottom of controller while providing a
drip loop.
2. Install and route a 1/2 in. CPVC drain hose from the bottom of the
controller box out of trailer floor.
Alternative Wire Routing (Steps 3-10)
NOTE: The alternative routing of the electrical harness chase and
interface harness is from the side
of the controller box.
3. Drill an appropriate size hole in the controller box for the harness chase
coupling.
4. Install harness chase coupling.
NOTE: Coupling should not protrude more than 6.4 mm (0.25 in.)
inside the controller box.
5. Install cap in bottom of controller box before foaming trailer wall.
6. Apply chalking to controller box and install securely into trailer wall.
Harness Connections
7. Apply Superlube (or equivalent) to Remote Controller Harness
connector and attach securely to back of controller. Route harness
through chase. Secure controller to controller box with screws.
8. Route chase and Remote Controller Harness from controller to host
unit. Secure with clamps.
9. Cut off excess harness and strip wire ends.
• Attach the Remote Controller Harness wires to the splice
connectors on the Interface Harness.
.
10. Apply Superlube (or equivalent) and securely connect the Interface
Harness 8-PIN connector to the mating 8-PIN Remote Controller
connector located on the side of the evaporator housing.
DANGER: Do not route electrical harness together with fuel
lines as this could cause a fire resulting in death or serious
injury!
CAUTION: Do not drill holes into refrigeration, electrical or
mechanical components or severe damage to the equipment
will result!
Remote Controller
Harness
(with flat 8-PIN connector)
Code Interface Harness
(with 8-PIN connector
and splice ends)
Code
PIN 1 BLU PIN 3 BLU
PIN 2 GRN PIN 5 GRN
PIN 3
No
Connection
PIN 7
No
Connection
PIN 4 ORN PIN 6 ORN
PIN 5 YEL PIN 4 YEL
PIN 6 BRN PIN 8 BRN
PIN 7 BLK PIN 1
BLK
PIN 8 RED PIN 2 RED