Installation manual

40
Installing the Fuel Lines
Fuel Line Installation
1. Install the fuel line bracket to the pre-drilled hole in the frame. This
hole is located in the frame under the compressor (Detail I).
IMPORTANT: Verify the factory installed fuel line fittings are tight
prior to mounting the bracket onto the frame.
2. Fuel lines should be routed in a protective housing with no kinks or
sharp bends (Detail II).
3. Rubber grommets must be used when routing fuel lines through holes
in metal (Detail II).
4. Secure all fuel lines with provided clamps (Detail III).
5. Route fuel supply line from the unit to the fuel pump to the fuel pickup
on the fuel tank. Install fuel line connector (provided in installation kit),
cut end of fuel line at a 45 degree angle and insert into fuel pickup tube
until it is 25.4 mm (1.00 in.) from bottom of tank and tighten securely
(Detail IV).
6. Route fuel return line from the unit to the fuel tank return fitting.
Attach fuel line connectors and tighten securely.
7. Remove plastic cap from the fuel vent and point the outlet to the rear of
the trailer.
NOTE: Add a sufficient amount of fuel (1/4 tank) to allow the unit to
run for 8 to 12 hours during engine break-in and pre-delivery
procedures.
DANGER: Leaking fuel lines could cause a fire resulting in
death or serious injury! All fuel line fittings must be tight and
leak free!
DANGER: Do not route fuel lines with battery cables or
electrical wires, as this could cause a fire!