Installation manual

30
Installing the Unit
Access to Mounting Holes (Detail II)
1. Top side mounting hole through the hinged roadside grille.
2. Center side mounting hole through hinged roadside grille.
3. Lower side mounting hole through hinged roadside panel, and control
box hole.
4. Center side mounting hole through hinged lower curbside door.
5. Lower side mounting hole through hinged curbside panel.
6. Center side mounting hole through hinged curbside grille.
7. Top side mounting hole through hinged curbside grille.
8. Top center mounting hole from top of the unit.
Unit Installation
9. Install two 5/8-11 forged lifting eyebolts into threaded holes located on
the top of the unit (Detail I).
10. Use the lifting bar to lift unit up to the trailer opening.
NOTE: All nuts that hold the unit to the trailer should be elastic stop
nuts (Nylock Type) provided in the installation kit.
11. Attach washer and elastic stop nuts provided in the installation kit.
Torque to 82 N•m (60 ft. lbs.).
WARNING: Do not use a forklift to install the unit! This could
result in severe damage to equipment, void the warranty or
cause personal injury or death!
WARNING: Use only locking hooks to safely lift the unit!
Failure to use locking hooks could result in severe damage to
the equipment, void the warranty or cause personal injury or
death! (Detail I).
WARNING: Thermo King requires a 3 point lifting bar to safely
lift and install units. A lifting bar can be made from the
drawings provided. See “Lifting Bar Dimensions” on page 18.