Installation manual

28
Unpacking the Unit
Units are shipped attached to disposable wooden pallet wrapped with
protective cardboard and plastic stretch wrap.
NOTE: To avoid unnecessary damage to your unit, place the crated
unit near the trailer prior to its removal.
IMPORTANT: DO NOT use a sharp knife to remove the stretch wrap or
cardboard wrap as damage to the exterior of the unit will result!
Unpacking the Unit
• Carefully remove plastic stretch wrap from unit.
• Carefully remove the top cardboard cover.
• Carefully remove the outer cardboard wrap.
• Remove installation kit boxes, bottom panel, and any other loose
components from rear of unit.
• Attach forged eyebolts and 3 point lifting bar to unit.
• Remove hardware holding unit to wooden pallet.
• Unit is now ready for installation.
DANGER: Do not use a forklift to install the unit! This could
result in severe damage to the equipment, void the warranty
or cause personal injury or death!
WARNING: Thermo King requires a 3 point lifting bar to safely
lift and install units. A lifting bar can be made from the
drawings provided (see Lifting Bar Dimensions).