Installation manual

Mounting Hardware Requirements

Mounting Bolts

NOTE: The location of the unit mounting bolts in the trailer front wall

is critical to proper unit installation.

All mounting bolts must be square with the front wall and securely

fastened to the trailer wall in such a manner to allow the mounting nuts be

torqued to 82 N•m (60 ft. lbs.) from outside the trailer.

• Mounting bolts are to extend a minimum 57.20 mm (2.25 in.) and a

maximum of 63.50 mm (2.50 in.) beyond the front wall.

• Surface of all mounting bolts are to be flat within 2.50 mm

(0.10 in.).

Mounting Bolt Specifications

Use Metric M12 x 1.75 pitch class 8.8 (1/2 in.-13 UNC - 28 Rolled thread

grade 5), medium carbon steel bolts and locking nuts. All hardware must

be zinc plated with dichromate finish.

DANGER: Eight mounting bolts must be installed to properly

secure the unit to the trailer front wall! Failure to do so could

result in severe damage to equipment, void the warranty or

cause personal injury or death!

DANGER: The use of mounting bolts other than those

specified could result in severe damage to equipment, void

the warranty or cause personal injury or death!