Instruction manual

MULTILINK MC-E10 & MC-E100 CONVERTER SWITCH
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 3
POWER CONSUMPTION
3 watts typical and 4 watts max. for all models
Note
8-15V DC can be used for dual source DC input
Note
Internal DC power floats, user may ground “+” or “-” if desired.
PORT CONNECTORS
RJ-45 Port: ...............................................................................................Auto-cross (MDIX), 100BASE-TX and
10BASE-T:shielded 8-pin female.
Three RJ-45 port provided in front and
one on the rear. Supports shielded
(STP) and unshielded (UTP) Cat 3,4,5
cable. For POE pass-through option
on H and P models, request quote.
SWITCHES
Fiber Port # 1 is controlled by an “F – H” switch, provided underneath port
“F” enables Full duplex to the fiber port #1
“H” enables Half duplex to the fiber port # 1
LED INDICATORS (DUAL- FRONT AND END)
POWER: .......................................................................................................Steady On when power applied
10/100:........................................................................................................ ON = 100Mbps; OFF = 10 Mbps
LK/ACT:........................................................................................................Steady On for LINK (LK) with no traffic,
blinking indicates port is transmitting
/ receiving (ACT).
F/H: ..............................................................................................................ON = full-duplex, OFF = half-duplex
MOUNTING OPTIONS FOR MULTILINK MC-E10 & MC-E100 FAMILY OF SWITCHES
Metal Mounting clips for panel mounting: .................................Included
DIN-Rail mounting option: ................................................................Model # DIN-RAIL MC2 (see Section
3.4)
Rack-mount option: ............................................................................MC14-TRAY, see
URL
MEAN TIME BETWEEN FAILURE (MTBF)
15+ years, Telcordia (Bellcore) Method
AGENCY APPROVALS AND STANDARD COMPLIANCE
UL Listed (UL 60950), cUL, CB, CE Low Volt. Dir. & Electro-Mag. Comp.
Emissions: .................................................................................................Meets FCC Part 15 Class A and ETSI
IEEE P1613 Environmental Std for
Electric Power Substations.
UL 2043 for above-the –ceiling
(plenum) installation.
NEMA TS-2 (1998) for traffic control
equipment.
WARRANTY
Three years, return to factory ..........................................................Made in USA