Instruction manual

These instructions do not purport to cover all details or variations in equipment nor provide

for every possible contingency to be met in connection with installation, operation, or

maintenance. Should further information be desired or should particular problems arise

which are not covered sufficiently for the purchaser’s purpose, the matter should be referred

to the General Electric Company.

To the extent required the products described herein meet applicable ANSI, IEEE, and NEMA

standards; but no such assurance is given with respect to local codes and ordinances

because they vary greatly.

GE Multilin Multilink MC-E10 & MC-E100 instruction manual for revision 1.x.

Multilink MC-E10 & MC-E100 is a registered trademark of GE Multilin Inc.

Ethernet is a trademark of Xerox Corporation.

NEBS is a trademark of Telcordia Technologies.

UL is a registered trademark of Underwriters Laboratories.

The contents of this manual are the property of GE Multilin Inc. This documentation is

furnished on license and may not be reproduced in whole or in part without the permission

of GE Multilin. The content of this manual is for informational use only and is subject to

change without notice.

Part numbers contained in this manual are subject to change without notice, and should

therefore be verified by GE Multilin before ordering.

Part number: 1601-9088-A1 (April 2009)

Federal Communications Commission

Radio Frequency Interference Statement

This equipment generates, uses and can radiate frequency energy and if not installed and

used properly, that is in strict accordance with the manufacturer's instructions, may cause

interference to radio communication. It has been tested and found to comply with the

limits for a Class A computing device in accordance with the specifications in Subpart J of

Part 15 of FCC rules, which are designed to provide reasonable protection against such

interference when operated in a commercial environment. Operation of this equipment in

a residential area is likely to cause interference, in which case the user at his own expense

will be required to take whatever measures may be required to correct the interference.

Electrical Safety requirements:

1. This product is to be installed Only in Restricted Access Areas (Dedicated Equipment

Rooms, Electrical Closets, or the like).

2. 48VDC products shall be installed with a readily accessible disconnect device in the

building installation supply circuit to the product.

3. This product shall be provided with a maximum 10A DC Listed fuse or circuit breaker in

the supply circuit when connected to a 48V centralized DC source.

4. The external power supply for DC units shall be a Listed, Direct Plug In power unit,

marked Class 2, or Listed ITE Power Supply, marked LP, which has suitably rated

output voltage (i.e. 24VDC or 48VDC) and suitable rated output current.

Product does not contain user replaceable fuses. Any internal fuses can ONLY be replaced

by GE Multilin personnel through the RMA process.