Specifications

13
BRASS COMPRESSION TEE
(compression x compression x thread)
Materials List
Using the plot plan and the check lists below, do a take-off to
determine your Materials List. If you are unsure what a part is
called, check the Sprinkler System Overview. Use colored pencils
and as you count or measure each component, mark the plan and
write the item down here on this Materials List. Make sure to list
everything on your plan.
1. Point of Connection: Detail and list the materials needed
by size. Check the backow prevention requirements for
your area and record the materials needed.
2. Pipe: Measure and list pipe by size. Be sure to add a little
additional pipe for waste. Count and list the number of
main line and lateral line ttings by size and type.
1. Exterior Point of Connection – Non Freezing
2. Interior Point of Connection – Freezing Climates
VALVE BOX SQUARE OR ROUND
POINT OF CONNECTION (P.O.C.)
BRASS GATE
VALVE
OR BRASS
BALL VALVE
WATER METER
BRASS GATE
VALVE
OR BRASS
BALL VALVE
POINT OF
CONNECTION
(P.O.C.)
MALE ADAPTER
WATER METER
BRASS COMPRESSION TEE
(compression x compression x thread)
1. Point of ConneCtion
List all the items needed for the system’s point of connection.
Brass Compression Tee
(compression x compression x
thread)
Brass Gate Valve or
Brass Ball Valve
Valve Box
2. PiPe And fittings (CAlCulAte the length of PiPe And number of fittings required.)
PVC (slip x slip x slip)
20 mm 25 mm 32 mm
Poly (compression or barbed insert ttings)
PVC PIPE
METERS REQUIRED
MAIN MAIN
POLYETHYLENE PIPE
METERS REQUIRED
LATERAL LATERAL
TEE
S x S x S i x i x i
TEE
S x S x 13 mm (½")T i x i x 13 mm (½")T
S x S x 20 mm (¾")T i x i x 20 mm (¾")T
ELBOW
90° x S x S 90° x i x i
ELBOW
90° S x 20 mm (¾")T 90° i x 20 mm (¾")T
90° S x 25 mm (1")T 90° i x 25 mm (1")T
45° x S x S 45° x i x i
REDUCER
BRUSHING
25 mm S x 20 mm (¾")S 25 mm (1")i x 20 mm (¾")i
32 mm S x 25 mm (1")S
32 mm (1¼")i x 25 mm
(1")i
S x S x S i x i x i
MALE
ADAPTERS
S x T i x T
MALE
ADAPTERS
COUPLING
S x S i x i
COUPLING
S = Slip Fitting T = Threaded Fitting i = Compression or Insert Connection
REDUCING
TEE
REDUCER
COUPLING
REDUCING
TEE