Product manual

Expanding Communications
LHM-401
225 Industry Parkway - Nicholasville, KY 40356 - Ph. 800-535-4651
LINE
HUNTER
1
LINE
2 3 4
1 2 3 4 5 6 7 8 9 10 11 12
LINE 1 LINE 2 LINE 3 LINE 4
POWER
MULTI-LINK
DIP SWITCH: There is a six position DIP switch that will enable/disable any phone lines connected to it (follow
silk-screen on back panel for position selection). The DIP switch will also enable/disable a busy signal for
outbound calls when the phone lines are not available. It is recommended to disable any line that is not in use
for the Line Hunter to be more efficient when hunting for any available line. Changes to the DIP switch settings
take place immediately. Power does not need to be re-applied.
LED INDICATORS: It has one green LED to show power status and four red LEDs to show the status of the 4
lines. The red LED indicators will glow solid when the line is in use. They will flash if the line is enabled by the DIP
switch but determined to be non-functioning, and the indicators will remain off if the line is disabled by the DIP
switch or is idle.
FRONT PANEL - DEVICE INTERFACE: The Line Hunter is equipped with 8-position modular jack interface
(sometimes referred to as RJ-45) on the device side (front). 8-position jacks are universal interfaces and can
accommodate another 8-position jack or a smaller 6-position modular jack (sometimes referred to as RJ-11).
Either type of modular jack will provide optimum performance.
REAR PANEL - TELEPHONE LINE INTERFACE
Four 110-Type, 4-pair connectors are provided on the line side. Termination is made to the BLUE/WHITE
insulation displacement connector.
POWER SWITCH AND CIRCUIT BREAKER (FUSE)
The Line Hunter comes with a Power switch and a circuit breaker that is manually reset.
LINE 4
LINE 3
LINE 2
LINE 1
Ports 1-6
NO BUSY SIGNAL
BUSY SIGNAL
Ports 7-12
Dip Switch Programming
AVAILABLE
NOT AVAILABLE
LED Indicators
110-D-4 Connectors
Power Rocker Switch
Fuse (Manual Reset)
DIP Switch Programming
8-Position Modular Jacks
Power Indicator
LINE 4
LINE 3
LINE 2
LINE 1
Ports 1-6
NO BUSY SIGNALAVAILABLE
BUSY SIGNALNOT AVAILABLE
Ports 7-12
POWER
FUSE
ON
LINE 1
BL/W
LINE 2
BL/W
LINE 3
BL/W
LINE 4
BL/W
FRONT - DEVICE INTERFACE BACK - LINE INTERFACE
7