Operating instructions

PROGRAMMABLE
FEATURES
NIGHT FUNCTION IN CALL OPTI-MIZER
~1
7) Press one of the keys 1 through 9 to set
the maximum number of rings that an
incoming call will ring DEVICE 1 when NIGHT
FUNCTION has been activated if CALL
OPTI-MIZER is on. If CALL OPTI-MIZER is
off, press the 2 key.
11
8) At this time, one of the LEDs should light up
indicating the current operating mode.
(The arrows (+ ) in the preceding charts
indicate the factory settings)
7.5 FACTORY SETTINGS
When your ATX-300 was shipped to you, it
was programmed with the following settings:
DEVICE 1 DEVICE 1
SELECTION
I
DEVICE 2
CODES
DEVICE 3
START MODE
ADDITIONAL RING
DELAY
CALL OPTI-MIZER
FAX TONE SELECTION
PROTECTED HOOK FLASH
EXPANDED FEATURES
1 MAXIMUM NUMBER OF RINGS
1 6 1
l3dEl
Em
Em
AUTO
OFF
OFF
09°F
ACTIVATE NIGHT FUNCTION
I I
5
IN CALL OPTI-MIZER
NUMBER OF RINGS TO DEVICE 2
IN NIGHT FUNCTION
I I
2
7.6 RESTORING THE
FACTORY SETTINGS
To restore all the programmable features to
the original factory settings:
1) Attach a tone-dialing phone to a DEVICE
port of your ATX-300. Attach the LINE
connector to an incoming telephone company
line.
2) HOLD the front panel push button switch in
for 3 seconds until the STBY indicator LED
begins to blink. Release the push button
switch.
3) Pick up the handset from the phone you
attached to your ATX-300.
4) HOLD the push button switch in until the
STBY LED stops blinking. Release the push
button switch.
5) IMMEDIATELY press the
0 key on your
telephone. This must be done within the first
1.5 seconds after the LED stops blinking. One
of the LED’s on your ATX-300 should now
glow steady. Hang the phone up.
6) Set the configuration switches (located on
the back of your ATX-300) according to the
chart below. Set switches 1 and 6 UP, and
switches 2,3,4, and 5 DOWN.
VERSA-LINK ATX-300
23
* 7.6 continued on next page