Operating instructions

PROGRAMMAELE
FEATURES
To program your ATX300 for “Calling
Number I.D.” compatibility:
1. Attach a tone-dialing phone to a device
port of the ATX300. Attach the line connec-
tor to an incoming telephone company line.
2. Hold the front panel push button switch in
for at least 3 seconds until the STBY
indicator light begins to blink. Release the
push button switch.
3. Pick-up the handset of the telephone you
have attached to your ATX-300.
4. Hold the push button switch in until the
STBY light stops blinking.
5. Immediately press the
*
key on your
telephone. This must be done within the first
1’12 seconds after the STBY light stops
blinking.
6. Now press the 1 key to program “Calling
Number I.D.” compatibility function. To
defeat the Call I.D. function, simply repeat
steps 1 through 5 and then press
0.
7.4 EXPANDED
Fii!zis-=
Normally, your ATX-300 will only ring DEVICE
1 up to 6 times on an incoming call in AUTO
MODE. Also, it will only ring the selected
device up to six times if a call is re-routed by
the auto-dial FAX tone or a device selection
code.
This maximum number of rings (factory set at
6) can be changed by re-programming your
ATX-300.
You can also change the ring settings
associated with CALL OPTI-MIZER: the
number of rings that activate NIGHT
FUNCTION (factory set at
5), and the number
of
rings that an incoming call will ring DEVICE
1 when NIGHT FUNCTION is activated
(factory set at 2).
CHANGING THE
EXPANDED FEATURES
The expanded features are programmed by
pressing keys on a tone-dialing phone
attached to one of the DEVICE connectors on
the back of your ATX-300. The incoming
telephone line must also be attached to the
ATX-300 LINE connector.
1) HOLD the front panel push button switch in
for about 3 seconds until the STBY LED
starts blinking.
2) Release the push button switch. The STBY
LED will remain blinking.
3) HOLD the push button switch in until the
LED stops blinking. Release the push button
switch.
4) IMMEDIATELY press the
# key on your
telephone. This must be done within the first
1.5 seconds after the LED stops blinking. The
LEDs should remain off until you complete the
expanded features programming.
5 Press one of the keys 5 through 9,
*
,
0, or # to set the desired maximum number
of rings that your ATX-300 will generate to
DEVICE 1 in AUTO mode or any device after
a call is re-routed:
MAXIMUM NUMBER OF RINGS
I2 - 9 rings
l3l - 10 rings
0 - 15 rings
ITI - 20 rings
6) Press one of the keys 4 through 9 to set
the desired number of rings to activate NIGHT
FUNCTION if CALL OPTI-MIZER is on. If
CALL OPTI-MIZER is off, press the 5 key.
VERSA-LINK ATX-300
22