Operating instructions

INSTALLATION
5.4.1 Adding FAX to a
voice line
When adding FAX to a voice line, attach your
FAX to the DEVICE 2 connector on the back
of your
ATX-300 See your installation manual
for details.
f
Operate your ATX-300 in AUTO mode. Also,
activate auto FAX tone detection. Configu-
ration switches 1 and 6 should be set to the
“up” position. This is the factory setting.
If necessary, change the configuration
switches on the back of your ATX-300. Unplug
the ATX-300 power cord for about 2 seconds
and re-connect it to activate the new settings.
In addition, you may also want to turn on CALL
OPTI-MIZER if you are using your ATX-300
on a multi-line system. See section 4.2.3 for
details.
5.4.2 Adding voice to a
FAX line
If you are expanding the use of your FAX line
you will want to move your telephone system
to the DEVICE 2 connector and attach your
FAX machine to DEVICE 1. This will allow all
incoming calls to go directly to your FAX
machine. Outbound calls can be made as .
usual, and incoming calls are possible using
manual transfer.
You will want to disable auto FAX tone
detection. Set the configuration switch position
6 to the “down” position.
Unplug the power cord from your
ATX-300 for
about 2 seconds and re-connect it to activate
the new switch settings.
In addition, you may want to operate your
ATX-300 in SEMI mode if 100% of the
incoming traffic for this line will go to the FAX
machine. See section 6.2 for a description of
SEMI mode.
5.4.3 Allowing two or more
data devices to share
one line
If you are using FAX, attach your FAX
machine to the DEVICE 1 connector on the
back of your ATX-300. Attach your other data
devices to the DEVICE 2 and DEVICE 3
connectors.
VERSA-LINK ATX-300
15