Installation Instructions

TECHNICAL MANUAL TS 3x.10 KNX – ENGLISH
4
Overview parameters
Parameters
Subcategory parameters
Description
Global
settings
Global settings
Send „in operation “(incl. cycle time), request status (active/inactive, request with…), send delay after bus voltage recovers in seconds.
Temperature
Temperature sensor Settings temperature sensor: Enable – disable, send measured values, offset adjustment, notification of sensor error, external value
enabled/disabled.
Temperature alarms
Settings frost- and/or heat alarms: Enable – disable, send measured values.
Temperature control
Settings temperature control: Type (inactive, heating, cooling, heating & cooling), different control values (extra cooling level & guide).
Inputs
General
E1…E5 general
E1…E5 parameters
Limitation of number and interval of telegrams to be send
Labeling of inputs, selection of function as analogue-/binary-/temperature input (functions depending on input)
Binary input: switching/alarm, dimming, blinds/shutters, value, scene, switching sequences, multiple operation, pulse counter
Analogue input (E1 only): Voltage, upper/lower measuring limits, output value, threshhold, limits changeable via bus
Temperature sensor input (E4/5 only): Function temperature / temperature limiter floor heater, sensor type, offset, error compensation,
threshold 1, threshold 2