Instructions

BA 873040led N;DE,GB -23435- 2015.03V01
INSTRUCTION MANUAL DIMMER [LED STRIPES]
Technical Features
Safetey instructions
Supply voltage
12 – 48 VDC*
CAUTION!! DANGER OF LIFE / RISK OF FIRE AND ELECTRIC SHOCK!!
Power consumption
0,5 VA
Suitable type of lamps
Dimmable LED lamps
Maximum load
6A
 Installation and assembly of electrical equipment must be carried out only by professional electrician!

Connect the supply voltage/frequency as stated on the product!

Disconnect device from power supply for wiring and installation purposes!

Check power supply is disconnected!

Defective devices have to be put out of service immediately

No safe electrical isolation between the power supply and pushbutton 2!
When using a 230V~ pushbutton on P
L
und P
N
no low voltage protection, no SELV!
Warranty void if housing opened by unauthorized person!
The electronic circuit is protected against a wide range of external influences. Incorrect operating may occur if
external influences exceed certain limits!
Installation and assembly of electrical equipment must be in accordance with local building and electrical codes
Max. number of pushbuttons
Unlimited (non-lighted pushbuttons)
Pushbutton 1
Pushbutton referred to Ground
Optional: Pushbutton 2
Pushbutton referred to 230V~ (no SELV)
Dimensions
46 x 42 x 13 mm
Weight
23 g
Permitted ambient temperature
Storage temperature
0º … +40ºC
-30º … +70ºC
Type of protection
IP20 according to DIN EN 60529
*NOTE: The power supply associated with this dimmer should comply with the Low Voltage Directive 2006/95/EC and EMC
Directive 2004/108/EC
Important Note

For all lamps, please take into account the specifications of the manufacturer!
Description / Installation / Operation
Wiring diagram
Description / Intended use

Dimmer for LED lamps 12 - 48VDC up to 6A, with Pulse Width Modulation technology (PWM),
specially designed for 1-channel LED strips.

Small size dimmer, for flush-mounting (e.g. behind standard pushbutton).

Protected against overload and short circuit. Built-in heat protection.

Can be used with a pushbutton referred to Ground (Pushbutt
on 1) or a pushbutton referred to 230V~ (Pushbutton 2) or both.
When using a 230V~ pushbutton on P
L
und P
N
the low voltages are not SELV!

With or without memory function.

With two function rotary switches:
min: minimum brightness level (1% up to ~60%).
dim speed: dimming speed between 3 and 10 sec. (from 0 to 100%).
Installation
1 Disconnect installation from power supply and check that power supply is disconnected.
2 Install the dimmer according to the wiring diagram.
3 Make sure the loads are connected properly and reconnect power supply.
4 Press shortly the pushbutton to switch the lamps on and dim with a long press to the minimum brightness level.
5 If you like the change the minimum brightness level you have to disconnect the installation again from power supply and set
with the rotary switch (min) the desired minimum brightness level.
.
Operation

Press shortly the pushbutton to switch the lamps on and off!
=> Switch on „No Mem“ = Lamp(s) switches on with max. brightness.
=> Switch on „Mem“ = Lamp(s) switches on with the brightness of the last switch off

With a long press you can dim!