Instructions

tint ceiling spots NALO
72
INSTRUCTION MANUAL
Problem Possible causes
I cannot add the tint product. The tint product is already assigned
to a remote control or a gateway.
Please remove it from the existing
network
Bring it closer to the remote control
Switch off any nearby Zigbee devices
I have to press the standby button
several times.
If the tint product has previously
been switched off using the light
switch, the tint remote control will
have to resynchronise.
You have switched off parts of the
system using a light switch. The tint
remote control is resynchronising.
Which group is my tint product in at
the moment?
Simply switching the groups on and
off again will tell you which group
your tint product is in.
Answers to other frequently asked questions, see www.mueller-licht.de/tint
Technical data
Frequency band of wireless RF mode: 2405-2480.0 MHz
Maximum transmission power: <20 mW
Radio range (free field): 30 m
Remote control: 3V (2x AAA/LR03)
Environmental conditions:
Temperature (operation): -20 ° C ... 40 ° C
Temperature (storage): -25 ° C ... 60 ° C
Relative humidity: 5-95% (no condensation)