Instructions

tint ceiling spots NALO

INSTRUCTION MANUAL

Resetting the tint remote control

A reset is only necessary in exceptional cases, for example if the tint

products do not respond to the tint remote control even after removing

and reinserting the batteries.

NOTICE!

Resetting the remote control will delete all pre-deﬁned group

settings and you will have to connect the tint remote control and

the tint products again afterwards.

1. Remove the battery compartment cover.

2. Use a pointed object to press the reset button on the back of the

remote control for three seconds, until the control LED starts

ﬂashing. Wait until it stopped ﬂashing again.

3. Then, proceed as described in the section “Resetting the tint

tint product” and then as described in the section “Adding a new

tint product”. Each tint product will then have to be connected

individually one after the other. If, for example, three tint prod-

ucts belong to one group, you must repeat the steps in “Adding

a new tint product” 3 times.

Incorporating in a Zigbee gateway

Generally, a tint product can only be connected with a remote con-

trol or with a Smart Home System. In some Smart Home systems

with Zigbee, the tint remote control can also be incorporated so

that the tint products can then be controlled via remote control

or a Smart Home app or voice controller at the same time. For

instructions and additional information, go to