Instructions

tint ceiling spots NALO
INSTRUCTION MANUAL
69
Reset
Reset to 100% light
The tint light bulbs and luminaires can be easily reset by light switch to the
basic setting of warm white and 100% brightness. This may be necessary, for
example, if you have dimmed the tint products before and the remote control‘s
batteries are empty. This feature may also be used in the normal case if you do
not have the tint remote control on hand.
1. Use the light switch to switch the tint product off and on again 3 times
(interval: 1 second on, 3 seconds off).
2. The tint product will now start in its basic setting, warm white, 100%.
Resetting the tint product
Resetting the tint product is only required in exceptional cases,
such as when the remote control has had to be reset.
Note: All settings (such as the link to the remote control) are
reset. The tint product is then returned to coupling mode.
1. Switch the tint product on and off 5 times (follow the instruc-
tions of the respective product)
2. Switch the tint product on again. It will now begin to cycle
through its colors. The reset has occurred as desired and you
can now use the tint product as normal using your remote con-
trol or other Zigbee system.