Instructions

tint ceiling spots NALO
INSTRUCTION MANUAL
61
Installing the ceiling spots
See illustrations on page 76
1. Before installing, de-energise the mains wiring: Switch off the circuit brea-
ker, or remove the fuse and secure to prevent reactivation.
2. Use the wall bracket to mark the holes to be drilled in the ceiling.
Make sure not to drill any cables or pipes in the area.
Drill at the marked points and insert the dowels. Now fasten the bracket
with the corresponding screws.
3. Connect the connection cable to the terminal strip. Make sure that the
cables are secure.
4. Install the ceiling spots as shown in the illustration.
5. Reactivate the breaker.
fig. 1 fig. 2 fig. 3