User Guide

7
Assembly Instructions:
Column Adjustment
Tube:
Refer to figure 4 .
1. Place the base
assembly on the
floor.
2. Loosen the four
allen screws on
each tube
adjustment clamp
(1).
3. Slide the column adjustment tube through the tube
clamps.
4. Tighten all four allen screws on each tube clamp.
Anti- Tipper:
Refer to figure 4.
Slide the anti- tipper tube (2) up into the column adjustment
tube and replace the lower ball lock
pin. Adjust the anti - tipper wheels
so they are 1 to 2 from the
ground.
Column:
Refer to figure 5.
1. Loosen the levers (1) and remove
the ball lock pin (2).
2. Slide the rear column (3) into the
column adjustment tube.
3. Replace the ball lock pin and tighten the levers to lock
the column assembly in place. Keep reading for further
Figure 4
1
2
Figure 5
1
2
3