User Guide

the set screw.

Repeat on

opposite side.

Depth: Loosen

the bar clamp

(10) by

loosening the

allen screw (6)

on the top.

Loosen the lock

pin block (7) by

loosening the allen screw (8) on the side. Slide the

shoulder pad back/forth to the depth which provides the

appropriate amount of anterior support. Align the lock

pin block (7), with the plunger pin (which is in side the

lock pin block) on top so the shoulder pad will lock in

position when in use and when pivoted out of the way.

Tighten the allen screw (8) to secure the lock pin block

(7). Slide the bar clamp (10) against the pivot pin

receiver (10) to provide enough tension to lock the pivot.

Tighten the allen screw (6) to tighten the bar clamp (10).

Repeat for both sides.

Pivoting the shoulder pads: The shoulder pads can be

released and pivoted out of the way while placing the

child in or removing the child from the stander. Pull the

ring (13) on the back of the plunger pin to release the

pivot. To open, rotate the shoulder pad away from the

column until the pivot locks. Repeat for both sides. To

replace, pull the ring and rotate the shoulder pad in the

opposite direction until the pivot locks.

Figure 24