User Guide

20
Neckrest:
Refer to figure 22
Mounting:
1. To mount the Neckrest, first
remove the Headrest pad. Do
this by loosing the two allen
screws securing it to the
vertical hex bar coming out of
the top of the column.
2. Then, slip the Neckrest on to the top of the bar as shown
in figure 23.
Adjustments:
Height & Depth: Loosen the allen screws (2). Slide the
neckrest to the desired height and depth on the vertical hex
bar and retighten the screws.
Shoulder Pads:
Refer to figure 23
Mounting:
Same as Neckrest above.
Adjustments:
1. Height: Loosen the allen
screw on the bracket (1).
Slide the shoulder pads to
the desired position, and retighten the screw.
2. Width: (Refer to figure 24) Loosen the set screw (11) on
the bottom of the pivot pin receiver. Slide the receiver
along the hex cross bar (12) to the desired width. Tighten
Figure 23
1
2
1
2
Figure 22