User Guide

19
OPTIONS
Handholds with Arm Troughs:
Refer to figure
21.
Mounting
Instructions:
1. Connect the
cross bar (1)
to the back
column/seat
post with
four allen
screws (2).
2. Slide the arm trough tubes (4) into the clamps on the
cross bar, and tighten the allen screws to secure.
Adjustments:
1. Height: loosen the clamp situated on the end of the
extension tube (3), this enables the arm trough tube (4)
to be inserted at desired height
2. Width: Loosen the clamping screw and remove the ball
lock pin. Slide the extension tube to desired width.
Lock back in place with ball lock pin and tighten the
clamping screw.
3. Arm Trough angle: Loosen the 4 allen screws under the
arm troughs (5). Rotate the arm troughs to the desired
angle. Tighten the screws to secure.
4. Handle angle and depth: Loosen the allen screw at the
base of the handle (5). Place at the desired angle and
location. Tighten the screw to secure.
Figure 21
1
2
3
5
6
4