User Guide

7
Assembly Instructions:
Column Adjustment Tube:
Refer to figure 4
1. Place the base assembly on the floor.
2. Loosen the four allen screws on the
tube adjustment clamps (1).
3. Slide the column adjustment tube (2)
through the tube clamps.
4. Tighten all four allen screws on the
tube clamps.
Anti- Tipper:
Refer to figure 4
1. Remove the ball lock pin (3) from the column
adjustment tube.
2. Adjust the anti -tipper wheels so they are 1 to 2 from
the ground
Spring Stop Assembly:
Refer to figure 5
1. Remove the ball lock pin (1) and
attach the bottom end of the spring
stop assembly (2).
2. Reinsert the ball lock pin, to secure
it into place.
Figure 4
2
1
3
1
Figure 5
2
1