User Guide

10
FITTING INSTRUCTIONS
Measure the Child:
1. Trunk width: ___
2. Hip width: ___
3. Inseam to 1 below his/her axilla: ___
Sit Bar, Pelvic & Trunk Supports:
Refer to figure 8.
1. Open the front of the pelvic & trunk
support straps, by releasing the
buckles and unfastening the velcro.
2. Loosen the eight allen screws (1) on
the back of the four sling bar clamps.
3. Adjust the width of the trunk bars to
accommodate the child s chest (use
measurement #1 above). Make sure
the bars are symmetrical on both
sides. Tighten the four allen screws
on the trunk s sling bar clamps.
4. Repeat steps 2 & 3 for the pelvic support using
measurement #2 above.
5. Sit bar height: Remove the ball lock pin (2) and slide the
the sit bar along the front column. Initially place the sit
bar as high as possible on the column. Replace the ball
lock pin.
6. Pelvic support height: Loosen the two adjustment levers
(3) on the back of the pelvic support clamp plates. Place
the pelvic support assembly as close to the sit bar as
possible without preventing hip flexion. If this support is
too high or too low, it will not provide the stability
required for the child to step forward. Tighten both
levers.
Figure 8
1
4
3
2