User Guide

5
ASSEMBLY
Tools Required:
5/32 , 3/16 , 1/4 allen wrenches (included in the pouch)
Tape measure
Adjustment Levers:
Refer to figure 2.
The adjustment levers can be ratcheted so the
handle can rotate without affecting the
tightness of the screw.
1. Pull up lever to disengage.
2. Rotate the handle so it is not obstructed.
3. Release and let the handle slide back and
lock with the screw.
4. Continue tightening/loosening the screw
by rotating the handle and repeating steps
1- 3 as needed.
Ball Lock Pins:
Refer to figure 3.
1. Hold the head of the pin between your
index and middle finger.
2. Press in on the blue button with your
thumb while extracting (or inserting)
the pin.
Hand Knobs:
Refer to figure 4.
1. Release (unlock) the knob by turning
it counter - clockwise.
2. Lock the knob by turning it clock -
wise.
Figure 2
1
Figure 3
Figure 4