User Guide

21
the allen screw (6) to tighten the bar clamp. Repeat for both sides.
3. Width: Loosen the set screw (11) on the bottom of the pivot pin
receiver. Slide the receiver along the hex bar (12) to the desired width.
Tighten the set screw. Repeat for both sides.
4. Pivoting the shoulder pads: The shoulder pads can be released and
pivoted out of the way while placing the child in or removing the child
from the stander. Pull the ring on the back of the plunger pin to release
the pivot. To open, rotate the shoulder pad away from the column until
the pivot locks. Repeat for both sides. To replace, pull the ring and
rotate the shoulder pad in the opposite direction until the pivot locks.
Figure 32
7
10
5
3
8
11
6
12