User Guide

Shoulder Pad Assembly:

Attaching the shoulder pad assembly.

Refer to figure 31.

Remove the neckrest from the neckrest bar (1): Loosen the two allen

screws (2) on the ear clamp. Slide the neckrest off the neckrest bar.

Add the shoulder pad assembly: Loosen the allen screw (3) located on

the side of the cross bar bracket (4). Slide the cross bar bracket onto the

neckrest bar. Tighten the allen screw.

Replace the neckrest: Slide the neckrest onto the neckrest bar by

placing the neckrest bar between

the ear clamps. Tighten the two

allen screws (2).

Adjustments:

Refer to figure 31 & 32

Height: Loosen the allen screw

(3). Slide the cross bar bracket

along the neckrest bar to the

desired height. Tighten the screw.

Depth: Loosen the bar clamp (5)

by loosening the allen screw (6)

on the top. Loosen the lock pin

block (7) by loosening the allen

screw (8) on the side. Slide the

shoulder pad back/forth to the

depth which provides the

appropriate amount of anterior

support. Align the lock pin

block, with the plunger pin (9) on

top so the shoulder pad will lock

in position when in use and when

pivoted out of the way. Tighten

the allen screw (8) to secure the

lock pin block. Slide the bar

clamp against the pivot pin

receiver (10) to provide enough

tension to lock the pivot. Tighten

Figure 31